Try this: shut down the computer, and turn the gain (etc.) to their
correct settings. Then turn the K3 off and on again. Do the settings
reset? If so, the problem is in the K3. If not, it has something to do
with the computer and the program.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 16/06/2023 20:54, Russ Edelen wrote:
Some further info. Logging and control is via DXlab suite set up per the
wiki through a serial port. The controls respond in both directions and
the radio functions as expected during nets and general operation after
the mic settings are adjusted. The problem only occurs at startup. The
k3 and computer are shut down when not in use and the k3 is routed to a
dummy load. The computer is powered on first.
As I mentioned it's not every time but seems to be more often then not.
Thanks for any advice.
Russ, KG7VQ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
