Hi, Thanks to everyone that sent suggestions regarding my broken K2/10. I tried all suggestions but still broken, I did find that the frequency probe was broken though.
The probe is now fixed and have been able to go through the alignment steps from the manual. I got as far as the VCO alignment step. I was not able to get the 6 volts on R30. Adjusting the slug in L30 only resulted in a range of approx. 2.5 – 4.5 volts. To recap the events that led to the failure, the transceiver was working fine until I noticed that the power out on my external watt meter was about 50% higher than I set the power to. I was in the process of calibrating the internal ATU when the power cut out and left the K2 in this state. Any suggestions? Is there a service and repair facility for Elecraft rigs in the UK? Thanks Allan, G4NNJ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com