Hi all,
I am hoping someone can point me in the right direction here.
My SSB board seems to have developed a problem. TX is fine but RX is
really down. Even stations who would normally peg the S Meter barely
register. If I remove the board and jumper the 2 connectors, the
receiver springs into life. I have checked continuity on the torroids
and checked the pin diodes (in circuit with the diode position on my
DMM) and all seems to be well. Voltages on U1 appear to be ok but I am
getting a small reading on some of the pins that should read zero (in
the order of 150mV)
Any ideas chaps?
Ian
--
Ian J Maude G0VGS | Sysop GB7MBC DXCluster
http://www.gb7mbc.net
K2 #4044
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
