Bill, VE2WMA asked: On my K2, serial 3842, using the internal keyer, I always get a key pop sound but only on the initial make (the first dit or dah upon the rig cycling from rx to tx). It is sounds popping sound like a low frequency click or thud. It particularly annoying when using my Kenwood HS-5 headphones. My signal, when monitored on the air, is clean so the pop is not transmitted. Therefore, the problem must lie in the keyer monitor. Can someone advise where I might begin my troubleshoot or offer a solution?
------------------ Hi, Bill! Check your t-r parameter in the MENU. That's the transmit/receive delay. If it's too short, you'll often get that sort of thump win phones that don't offer good low-frequency roll-off. (Most modern headphones fall into that category, unfortunately). I keep mine at 0.10, but then I don't care about hearing a gnat sneeze between dits at 40 WPM, Hi! Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
