I've had my K2 kit for a few days and am about finished with the front panel. Before proceeding I have a couple of concerns.
1) As instructed, I did not remove the covering from either side of the diffuser backlight panel. However, I notice that it appears to have separated during assembly. There is a thin film bowed away from the panel. It's not clear what I can do about this, or if it is a serious problem. 2) In the reistance checks, everything seemed correct except for U1:pins 1&2 and J1 Pins 16&17. The manual states these should be 25k-40k, but I get about 22.5k for all of them. This is close, but is it a problem that the readings are not in the specified range? Thanks for any help! Bernie Gardner W1AZ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
