Hi Bill,
When you did your resistance checks for the front panel board, were any of
them outside of the expected range on the low side?
John, W2GW
----- Original Message -----
From: "Bill Carpenter" <[EMAIL PROTECTED]>
To: "elecraft list" <[email protected]>
Sent: Thursday, August 24, 2006 11:52 PM
Subject: [Elecraft] First Alignment and Test problem #5703
I got to the first test stage tonight and while the rig came on with no
smoke there is nothing on the LCD display. I hear the relays clicking and
the backlight is on but no characters at all. The front panel is plugged
in fine and I reset it just to make sure. Dittos for the control board.
All the intermediate resistance checks were. Any input as to where to
start looking would be appreciated!
Thanks and 73,
Bill NZ0T
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
