Then I suspect you powered the amp on before the transceiver, and the K3/K4 did not get the power-on message from the amp. Or perhaps there was some other reason the transceiver didn’t get that message. The amplifiers just report status to the radio; it is up to the radio to determine what it needs to do.
73, Jack, W6FB > On Oct 20, 2024, at 1:18 PM, Carl Yaffey <[email protected]> wrote: > > I was on 14074 for FT8. Power set to 98. Changed to 14303.5. Turned on the > KPA1500. Power stayed at 97! Manually changed power to 20. Turned off the > amp, power stayed at 20. > Set power to 97. Turned on amp and power went to 20 as it should. Could not > repeat this. > > Carl Yaffey K8NU > 614 268 6353, Columbus OH > http://www.carl-yaffey.com > http://www.bluesswing.com > http://www.timbrewolvesband.com > http://www.folkramblers.carl-yaffey.com > http://WalhallaRamblers.com > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
