One problem with just using the K2's CAT commands is that you can't get at
AF / RF gains, also tuning via CAT is a bit on the slow side. As I don't
have a K2 I can't look at what would be needed to enable access to AF/RF,
but this will surely be something being considered for the K3 :-)
In fact having a port on K3 which is similar to a laptop's docking port or
some other alternative would allow a third-party to develop an optional
front panel kit, freeing up the Elecraft design team from this chore.
Simon Brown
---
RSGB HF Convention October 2006: http://www.rsgb-hfc.org.uk/
----- Original Message -----
From: "Solosko, Robert B (Bob)" <[EMAIL PROTECTED]>
To: "Elecraft Discussion List" <[email protected]>
Sent: Wednesday, August 30, 2006 3:42 PM
Subject: [Elecraft] RE: K2 Front Panel Extension
Hello All,
Thanks everyone, there have been a lot of good suggestions. Some of them
seem to move beyond a simple front panel extension into the realm of a
remote front panel, which also has been explicitly mentioned. Perhaps
there could be two different products here, a simple front panel extension
and a separate remote front panel.
[chop-o-matic]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
