Petr,
Do not use the lower panel BNC connector if the KAT2 is installed.
There will be no power control and the K2 can be damaged due to
excessive PA current.
Use ANT1 or ANT2 on the KAT2 panel. The KAT2 can be either set to
bypass or do a TUNE into a 50 ohm dummy load using the ATU menu parameters.
73,
Don W3FPR
On 9/1/2025 12:09 PM, Petr Ourednik via Elecraft wrote:
Hi folks,
so sorry for stupid question.
My father (83) is trying to use his K2 with KAT2 ATU installed.
As he is using antenna with LDG tuner in attic at the feed point
he is not sure if he should use main ANT/50Ohm connector or one of
the Ant1/Ant2 on the rear panel. (he does not want to use internal KAT2) right
now.
He tried to put antenna to main ANT/50Ohms BNC connector and as it is listening,
he tried to key down and hoped that external tuner in attic works.
I am 200km away so I cannot check it, but I am worrying about the K2 finals if
the
antenna path is not correct and SWR exceeds limits.
I tried to read K2 manual, but I did not find to me clear info. I only found
the statement
"Do not use main ANT/50Ohm if ATU is installed" which makes me nervous.
Could someone be so kind to let me know or explain what is correct please?
Many thanks in advance.
(sorry I acquired K2 for father long time ago and I never used it as I am
driving K3...)
73 - Petr, OK1RP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
