To the original poster who could not even receive.
The RigBlaster is not used during receive. The audio goes straight
from the K2 (I use the ext speaker jack) to the Line IN jack on your
sound card. Until you can properly receive PSK, SSTV, RTTY, etc,
there is no point in connecting up the RigBlaster.
Once you have receive working, the instructions supplied for the K2
should work for transmitting but that will depend upon how you wired
the microphone connector on your K2. Make sure you have the
RigBlaster jumpered so that the signals appear on the same pins as
they do on your microphone.
The only problem I encountered was not being able to use the
microphone through the RigBlaster due to hum on my audio. I suspect
this is a grounding issue caused in part by not having the
microphione jack in the K2 grounded in my version, S/N 2221. Next
time I open it up for mods, it is my To Do list.
73,
Mike WA3KYY
At 07:55 PM 9/1/2006, Phil Kane wrote:
On Wed, 30 Aug 2006 11:02:12 -0400, H.Cary III wrote:
>Has anyone connected a RigBlaster with their K2 for SSTV or PSK-31? If
>so, I'd like to contact you off-line as I have some questions. I've
>wired the "pins" in the RigBlaster per the instructions for Elecraft and
>hooked it up to the computer properly but no luck receiving, etc.
>Thanks in advance for any help!
I'm using a RigBlaster Plus with a K2 and MixW, and it's been
trial-and-error to get it set up for data (PSK-31, etc).
I would also be interested in what others had to say about the
setup. Did you get any replies to your posting above? If so,
please share them with us, if you can.
--
73 de K2ASP - Phil Kane
Elecraft K2/100 5402
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
