Hi, everyone.
I am trying to rescuscitate my K2 after some problems with K60XV.
I have decided to re-do alignment procedures. Reason? I now realize
my 40M receive behaves differently than other bands even with the
K60XV removed.
I used the XG2 to cal the S-meter and could not get a reading of S9
for the 50 uV signal. I couldn't even hear the 1 uV sig.
So, now I am back to p. 60 of manual and re-doing the 4 MHz
oscillator cal.
Problem: I can't access TP3 while I have KDSP2 attached.
My question: Where exactly do I place jumpers on J1 and J2 of Control
Board?
Thanks
John
AB8O
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
