Can't help on the AWG engine, but I'm able to use RTTY and Slow Scan TV ( At
least receive). I'm using the MMSCTV and MMpkt drivers. They are a sound
card implementation.
I enabled the RTTY mode -- the 'r' mode using the secondary menu commands.
Using Spectrogram, I set the filters fairly wide - to about 2 Khz. The
configuration seems to work for me.
Good Luck !
Douglas Todd (KE7GYQ)
----- Original Message -----
From: "Bill Allen" <[EMAIL PROTECTED]>
To: "'Elecraft Reflector'" <[email protected]>
Sent: Sunday, September 10, 2006 2:54 PM
Subject: [Elecraft] AWG Packet Engine?
Has anyone had any luck using the AWG Packet Engine software for HF packet
with their K2? I just cannot seem to get tuned in well enough to decode
packets. Even on the OP1 filter, I am thinking that I am just to close to
the edge of the bandwidth of the filter to receive. Any ideas?
73, Bill Allen WA5PB
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
