Hi Gang,
This is my first post to the group and I am hoping you can help me.
After completing my K2 (s/n 5581) a couple months ago I was asked to
look at another local ham's K2 (s/n 600). All I was told was that it
didn't have any output and gave the Hi Cur warning with anything above
0.1 Watts. The radio itself is in good shape and only has the Noise
Blanker option installed. After some initial test I have found that
there is output, but the Hi Cur warning is still a problem. Using my
multimeter set to read current I found the a power setting of 0.2
Watts or higher will draw 2.4 Amps of current or more with the output
connected to a dummy load. I am guessing this may be a problem in the
PA, but would like some input on where to start looking. Any help
would be greatly appreciated.
73,
Kevin
KG4TEI
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
