Stephen W. Kercel AA4AK wrote:
I have a strange problem with my K2/100 on 80 meters.
The situation is as follows:
I work QRP DX at the low end of 80 M, (say 3508 kHz or thereabouts) with a
requested power of 4.5 watts, and get an indicated 5 watts out.
I then check into the Pine Tree Net on 3596 kHz and crank up the requested
power to 10 watts (this is before the relay clicks; I'm still in QRP
mode), and I get about 10 watts out. So far so good, right?
Then I go back to 3508 kHz, without resetting the power request level
knob, but the rig puts out 5 watts, even though the display acknowledges
my ten watt request. If I go back to 3596 the output goes back to 10 watts
in agreement with the requested level.
<snip>
Has anyone else run into this phenomenon?
-----------------------------------------------------------------
Steve,
After checking I find that my K2/100 #3255 behaves in the same way on 80m
when feeding a good dummy load. - do not have any 80m antenna. As you say
the problem does not appear to arise on other bands. I notice other strange
behaviour on 80m related to 'power request', but I would need to run various
tests before making any comment.
73,
Geoff
GM4ESD
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
