Hi everyone.
I am attempting to use the KAT100 for the first time and a new
homebrew G5RV.
Just finished the cabling and went successfully thru calibration
steps. Then, I put the covers on the KAT100. When I turned on the
K2, a click and no other response on K2, no LCD. No LEDs on KAT100
either.
Disconnect pwr to KAT: no change, disconnect RF between: no change,
disconnect RS232, now all is OK on K2. Made the obvious check of the
cable on both ends, and repositioned the leads.
I will continue to check for shorts in the cable after I get back
from work. However, I thought I'd ask whether there might be
something else to look at, as well.
I used adhesive pads on the bottom panel of the ATU.
Thanks,
John
AB8O
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
