Tod, Ok, you have an open circuit somewhere between the power supply and the anode of D2 - there are only a few pieces involved - the wire in the power cable, the male connector, the female connector in the KX1 and a bit of PC board trace going from the connector to the anode of D2. Continue the continuity testing on each piece and possibly through the mated connectors - sometimes connectors will fail to mate properly if one of then does not have adequate spring tension in the contacts.
You likely do not have a dead KX1, but you do have a dead power connection somewhere along the line. 73, Don W3FPR > -----Original Message----- > > There's no continuity between + and the D2 anode > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
