Hi,
I have for some time (1 year) a well functioning k2. Never bothered to do a proper frequency.calibration because I used the k2 as IF for VHF. Recently I tried to do so (according to the w3fpr method), but no luck. I can't get the dial correct and have a quite big error (2 KHz or so). It seems that there is no change at all when performing the calibration (yes I do PLL CAL and XFIL CAL.). I do have one question to start with: If you tune to a carrier (CW) signal and adjust C22 (on the control board, to adjust the 4MHz xtal osc) what should happen ? Should the pitch of the carrier change ? should the frequency readout change ? (With my K2 "nothing" happens, no change in pitch, no change in readout, is this normal ?.). Thanks in advance, Carel _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
