On Ken Kopp, K0PP's advice (nice call by the way), I checked for some
markings. With bright light and a magnifier I find it's an Andrew 42W
connector, of which there is little info on the internet. Except that
it's for use with hardline, 1/2" I believe.
But with some more poking around on the net I found the following:
http://www.amphenolrf.com/products/CatalogPages/typen_catalog.pdf
Page 2 of the pdf shows the length and diameter of the center pin! So
tomorrow I'll go mike mine up and from that i'll know what impedance
connector I have!
Thanks for the background info.
I think maybe I can adapt it for use with RG-213 / LMR400 / 9913F if it
is a 50 ohm job.
73,
Lenny W2BVH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
