I "hard reset" my K2 while trying to figure out why the KAT wasn't
working properly. I now know (thanks to Dave) that somehow the ATU
switched from "auto" setting.
Now, I have to reset / recalibrate. I re checked the 4MHz Osc
calibration, the PLL Reference Oscillator Range, the VCO test,
Redid the BFO test and range. All of these procedures were successful.
Redid CAL FIL and set all values to those in Table 8.2 on p 89 of the
manual.
***I heard a carrier on LSB and some USB (?)***
I did not re-align the cans.
Did not re-do VFO Linearization
Now, my XFIL settings are off...audio freq changes substantially
between X filters (but not between C filters)
My apologies for going over old ground, but what precisely did I mess
up? :)
John
AB8O
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
