I need to hang my head in shame. After sending the email, I was
looking in the schematic to see if there were any other places I could
test for a signal. That's when I realized there were 2 P5's. Of
course, I had plugged the speaker into the wrong one (on the control
board). Plugging it into the correct one makes all the difference!
Thanks for your help. I'll be more careful when I start on my KAT2.
73
Jay
KA9OKT
On 10/30/06, Jay Sissom <[EMAIL PROTECTED]> wrote:
My K2 is working! I finished it and the internal battery pack this
weekend. I started building it in July and 46 (non-consecutive) hours
later it works!
I have a problem with the speaker though. I hear the audio with
headphones plugged in, but don't hear anything through the speaker
with no headphones plugged in.
Can someone give me the pinout of the headphone jack? I wonder if the
switch inside the jack isn't working. I've tested the speaker and
it's wiring and that seems to be OK. The audio signal doesn't make it
to P5.
Once I get this fixed, then I have the KAT2, SSB & DSP options to build.
Thanks & 73
Jay
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
