Someone recently posted a problem similar to this. Of course I didn't
pay attention to the answer!
I recently changed the configuration of my station to connect an antenna
directly to the ANT 2 output of the KAT100. Previously, it was
connected through an automatic switching system, ultimately getting to
the ANT 1 output.
It's a reasonably well-matched 40 meter vertical. There's a choke balun
on it. I never had any trouble with it. But with the new
configuration, the KAT100 shows a matched condition up to about 60 watts
output. As power was increased above that, the indicated SWR starts to
increase, shooting up rapidly to the 'all LEDS lit condition'.
I 'fixed' the problem by adding about 6 feet to the coax feed to the
antenna.
My feeling is that the KPA100 is for some reason oscillating away from
the operating frequency when it sees a particular kind of load, which
the KAT100 is providing as a result of the load *it* is seeing!
I hope that's clear. I'll try to determine the frequency after this
coming Sweepstakes weekend.
For what it's worth, my KPA100 has all of the latest modifications,
including the shield kit, care paid to the RF choke location, etc.
Any comments?
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
