Bill:
You don't tell us where the MFJ is going into the line. Is the
same coax that feeds the antenna being plugged into the MFJ? or is it
reading from a different point?
dave belsley, w1euy
My K2/100 is indicating high current draw on a portion of 40 meters
but only on the antenna. On the dummy load there is no problem.
It's not high SWR as both antennas it happens with (double bazooka
and ground mounted Butternut vert) indicate low SWR on my MFJ
analyzer, SWR meter and the K2. This occurs at full power of around
100 watts. Any ideas on what may be causing this? I'm using my
Drake PS7 power supply which has more than enough amperage and
minimal voltage drop.
Thanks and 73,
Bill NZ0T
--------------------------------------------
david a belsley
professor of economics
boston college
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
