Thanks Steve and Don. The info is greatly appreciated. I did find C162,
and my mind is at ease re the holes. they look like pop through holes to
cross the trace on the back side of the board? Anyway, many thanks
Bill
NA7Y
----- Original Message -----
From: "Steve Banks" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, November 06, 2006 12:03 PM
Subject: RE: [Elecraft] Missing designation?
Bill,
I am pretty sure you are NOT missing a cap designation. Those two holes
are for another purpose and are not used for top-side components. I can't
recall the moniker used to name them, but I'm building a second K2 and
recall pondering the same question a few years ago when K2 S/N 1599 was
underway.
I think you may find that C162 is installed on the bottom side of the RF
board. Check it out.
Steve Banks
K0PQ
-----Original Message-----
From: "William M. Spaulding, SR"<[EMAIL PROTECTED]>
Sent: 11/6/06 11:50:38 AM
To: "Elecraft"<[email protected]>
Subject: [Elecraft] Missing designation?
Hi All,
On my RF board there are holes for a capacitor, but no designation.
The holes are right next to C159 and the Q22 heat sink. Anyone know what
capacitor that is? I am missing holes for C162 for instance.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
