ED,
I understand that you have had trouble operating your KX1 in cold
temperature. I just wanted to let you know that I have operated my KX1 in much
colder temperatures that + 20 degrees F. Last night I left my KX1 out all
night and it was below zero degrees F. This morning by the time I went outside
to see how it would work in the cold it had already warmed up to + 5 degrees F.
I used internal Lithium cells which were partially run down. Even with these
run down and very cold cells my KX1 still seemed to operate normally and put
out approximately 1 watt on all 4 bands. I switched to the menu position which
measures the battery voltage. I read 8 volts key up and approximately 7 volts
in the tune position. I think with fresher cells, or with 6 warm lithium cells
in an inside shirt pocket I would l have at least 1.5 watts output on all
bands. I have operated the KX1 in the past in cold temperatures, but do not
remember exactly how cold it was. I will do a test when we have some winter
weather and see how things work at 30 or 40 degrees below zero F and post the
results. When possible I always try and keep battery packs in an inside shirt
pocket for all electronics equipment, especially if it is well below freezing.
Lithium cells hold up better than many other types of cells, but even they lose
much of their capacity in cold temperatures.
One possibility is that when you went to the tune position the voltage
sagged below what is required for proper KX1 operation. In a warmer
temperature the same cells may have still worked. Try new Lithium cells, or a
warm external battery pack. If the problem is not battery related, try
operating the KX1 in cold temperatures without the back cover and tap or push
on various parts of the board, or parts. Often problems are thermally related
and may only show up in cold or hot conditions. A solder connection or circuit
board trace are real possibilities. Less likely (at +20 degrees F) would be a
component which does not operate in the cold.
Often oscillators will not start and other problems occur in new designs in
extreme cold temperatures, however the KX1 is a well proven design in
temperatures below where you had difficulty, so this would NOT be my first area
of investigation.
You might be able to find the sensitive area on your board by spraying some
of the COLD spray available from Radio Shack and other places on sepecific
parts of the board, and or components. The Cold spray might be especially
helpful after you get the problem isolated to a specific area of the board, or
a few suspicious components. Possibly you will need to remove the KX1
completely from its case and carefully distort or bend the board when it is
cold to trry and localize the problem.
Good luck in finding the problem, and be sure to post your findings on
the reflector.
Rick Dwight KL7CW KX1 # 798 Palmer, Alaska
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
