I stopped soldering connectors quite a few years ago and have gone to
crimp connections. Properly done, a crimp connection will make a
gas-tight seal and will be at least as reliable as a soldered
connection. It takes a bit less time than soldering and you don't have
to worry about melting the center conductor insulation (a real problem
with RG-174). Plus, if you are out in the backyard, you don't have to
run a long extension cord or use a butane-powered soldering iron to
install a connector.
Some connectors I use, such as the bulkhead SMA female cablejacks that
are part of the Z10000 buffer amplifier kit, require soldering the
center conductor, but the shield is crimped.
For PL259-style connectors, both the center pin and shell can be
crimped, along with some BNCs and N connectors. Others are center-pin
solder, shell crimp design.
In crimping the connector, it's critical that the tool used have the
correct die dimension and that you have stripped the shell and center
conductor to the manufacturer-specified length.
I did 150 crimp connections of rather small cable (some RG174 and some
Teflon coax that makes RG174 look large) recently and had one bad
connection, which was due to my error putting the connector into the
wrong die in the crimping tool.
I paid about $100 for my ratcheting-type crimping tool and two extra die
sets, but I see imported knock-offs with full die sets for a fraction of
that price now.
Jack K8ZOA
www.cliftonlaboratories.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
