John, You have substantiated that the problem was a BFO alignment problem. I would strongly urge you to check the FL1 passband using Spectrogram just to be certain you have the BFOs set correctly. It is easier to use than to tell you how to do it. There are instructions for using Spectrogram in the K2 Dial Calibration article at my website http://w3fpr.qrpradio.com
73, Don W3FPR > -----Original Message----- > The instructions for optimizing the BFOs say you can move the BFO as > much as +/- 200 Hz from the frequencies in Table 3. Moving them about > 100 Hz removed the raspiness, but I had to move them about 350 Hz total > before I considered the signal optimum. Is this setting OK or should I > back down to around 200 Hz? > > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.15.21/589 - Release Date: 12/15/2006 5:10 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
