Hi,
I have got to the stage where the physical construction of the RF board
on the K2 is complete and it is assembled except for the filter peaking.
I have noticed that the internal meter is jumping around somewhat at
times, although the analog meter I have in line with the dummy load does
not.
I noticed that when I applied power on 20 meters, and started tweaking
L8 and L9 the power went up and up to 8 watts, then when I did it again,
it was stable at around 2.0. Is that abnormal?
The S meter seems to jump around somewhat; that is, it jumps between two
adjacent bars (dot mode) on occasion.
I think that there may be a poor solder joint somewhere (historical
precedent ;-)).
Where should I start to look?
Thanks
--
David Dawson
The trouble with this country is that there are too many politicians
who believe, with a conviction based on experience, that you can fool
all of the people all of the time.
-- Franklin Adams
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
