Oops...typing too fast and stumbled over my words, Hi. Clearly the RF IS available at the BNC, but that's not where you're expected to attach the load. Ignore the BNC and use only the large Type N connector on KPA100.
Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ron D'Eau Claire Sent: Sunday, December 17, 2006 7:03 PM To: 'Glenn McNeil'; [email protected] Subject: RE: [Elecraft] KAT100 Query Hi, Glenn: The Owner's Manual will show you to connect the transverters to the output of the KPA100, even if you're set to an output of 5 watts (see Figure 2 on page 6 of the Owner's Manual). When you set the power to 10 watts or less the KPA100 is in bypass, but the RF is still routed to the large connector on the KPA100, not to the BNC. Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
