Hi Guys,
I seem to have K2 #5885 perking along quite well. I also installed
the NB, DSP, SSB board and 160 board. With those behind me, I'm on to
the KPA 100.
On my initial voltage checks, page 25 of the manual, I'm getting some
bad readings.
Test Point Reading Should be
U1 pin 1 7.0 5.0
U1 pin 7 8.0 0 - 0.1
U1 pin 13 7.0 0 - 0.1
U1 pin 20 7.0 5.0
U1 pin 27 7.6 5.8
U4 pin 11 5.8 5.0
I pulled U1, and all readings were within spec except for
U1 pin 7 13.1 0 - 0.1
U1 pin 27 8.0 5.8
So, it seems that voltage regulator U3 is OK, as it reads 5.0 with U1
out of the picture.
Could I have a bad Q12?, or is it possible U1 is the culprit, or ????
Thanks
Don
W0DJC
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
