I finished the control board and it looks good. I didn't like how the revised cap and resister went on the back side but otherwise it looks good. I did have a question. The IC #1 that I received was slightly different than specified. It is the only one left so I am assuming it is okay. I wanted confirmation before I solder, however. It is called for NE 602 and the IC I have is SA 612 C101708 Fn 344B. Is this okay to solder?
Thanks for all the help. Bill Koucky _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
