Hi Folks,
I am building #5930 and I'm at the point of installing
C91, C88 and RFC 15 on the bottom of the rf board at U4. The manual talks
about a miniature 100 uH choke, much smaller than the other 100 uH chokes and
with a tan body. I have 4 green bodied and one tan bodied 100 uH choke, but the tan bodied one is pretty close to the
same size as the green ones, if any thing a little bigger. I have no miniature chokes at all I'm sure I can
solder it to the indicated location, but is this something I should be
concerned about? Bernie W1AZ asked this same question on the list back in Sept.
but I can't see where anyone answered him.
Thanks in advance,
Bob K6GGO
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
