I'll bet you find out that the 1 K you put in was actually some other value
.. or .. something happened you did not plan (cold solder joint?). If the
value of 1K is too high for your particular K2/100 the output will not reach
full ratings on some bands but it will still be a lot higher than 0 or 1 !
Yep, use a pot or just patch in various fixed resistors like I did. I also
tested the value of the fixed resistor I was inserting just to make sure it
was what I thought it was.
Don K7FJ
----- Original Message -----
From: "Darwin, Keith" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Sunday, December 31, 2006 3:25 PM
Subject: [Elecraft] I changed K2 R98 to 1K - not good?
My K2/100 shows a lot of variation in TX output, esp. on 40 meters. I'll
set it for 50 watts and the power will toggle up and down by 10's of watts.
Time to change R98.
Checking old posts, I see that values of 1.1 KOhm seem to be good, I have a
1K resistor so I put that in. Put the rig back together and ...
Max output on 40 meters is about 3 watts. It is lower below and above 40
and on 20 or above there is no output. Hmmm, did I do bad?
My next step will be to parallel another R with R98 so I can drop the
resistance and see if I regain some power.
Sheesh, and this is on the eve of SKN too. What a bad time for my rig to be
down.
- Keith N1AS -
- K2 5411.ssb.100 -
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
