Scott, Sockets are not recommended - in the RF paths, they do create additional impedances that should be avoided, and they do reduce reliability unless they are air-tight (machine pin type) sockets due to slow oxidation of the metals.
If you prefer to take your chances, go ahead, but use good sockets (but use tin pins, not gold)., so the metal matches the legs of the ICs. 73, Don W3FPR > -----Original Message----- > > Due to a solder bridge on pins 2 and 3 of P2 on the control board of > my K2, I let the smoke out of U6, U7, and U8. U6 is mounted in an > IC socket. Is there any reason other than the cost, for not putting > U7 and U8 in sockets when I replace them? > Thanks > Scott N5SM > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.16.3/614 - Release Date: 1/2/2007 2:58 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
