My bare-bones K2 is almost completely assembled and ready for final testing.
I will probably build a KSB2 within the next few months. I don't expect to
add too many other options other than the KNB2, which I already have and
possibly the K160RX. How much work is to install the KSB2? Since everything
is still apart, is it worth getting any of the Un-module/Rework eliminators
or parts kits to save time later on? I can see where installing some headers
or caps now would be convenient, but don't want to over-complicate my final
testing and alignment process. I am a former electronic tech and not
bothered by unsoldering components.
Any suggestions are appreciated. This list has been a great resource during
my build process, which has gone very well. Thanks to all.
Phil Zminda N3ZP
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
