Hey folks...I just started building K2 #5945. Can't wait to get back
to the bench :)
As I was going through soldering the first few resistors and resistor
packs, I looked at my solder job through a magnifying glass and
noticed that it *looks* like pins 2 & 3 and 6 & 7 on RP1 (on the
control board) are tied together. Is that true? Electrically they are
now and as I pull more solder off it appears that it's meant to be
that way, but looking at the schematic, I'm not seeing it that way.
I know I'm missing something dumb, but I'm hoping someone will set me
straight and I can move on :)
Thanks for any ideas.
Jeff
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
