My K2 (5707) is now working great, including the KPA100 amplifier, after a little set back due to a very small wire strand across a couple of connector pins. Thanks to Gary Surrency's encouragement and advice I was able to find and correct the problem. At one point in the process, the radio got reset so that I had to redo the filter settings. It occurs to me that with the serial interface functioning, there should be a way to back up the filter settings to a computer and reload them if necessary. Looking through the KIO2 programmer's reference manual, it looks like all the commands to do that are available, but I can't find any programs which actually do this. Does anyone know of such a program?
Bernie, W1AZ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
