See this info on the Elecraft web site. http://www.elecraft.com/Apps/Builder%20Alert%20Installing%20Small%20Chokes%2 0Rev%20B.pdf
Or, for a short URL: http://tinyurl.com/yvm7vk Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jeff Kinzli Sent: Monday, January 29, 2007 9:16 PM To: [email protected] Subject: [Elecraft] KPA100 and RFC6, etc Hey guys, I'm working on KPA100, and at the step to install RFC6 and others. The board outlines and holes are for miniatures, but the only miniature I got was RFC9. Is it ok to bend the leads on the larger chokes to bend underneath the choke to make the holes? If I do this, the choke is about 0.25" off the board, is that ok? Thanks, -Jeff _ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
