It sounds like a power supply problem. I would look at the voltage you are supplying both at the supply itself and in the K2's display and watch it. I've seen people that use too small wire or have a bad connection to the K2 and as you pull current it heats up the connection and creates a voltage drop and the K2 will then reset.
Good Luck, Gregg W9DHI -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Richard Haendel Sent: Saturday, February 03, 2007 4:47 PM To: [email protected] Subject: [Elecraft] K2 stops keying I have a weird problem. I'm running my K2 about 10 watts into an amplifier. When I am in a ragchew QSO on CW, the K2 stops keying after about 60-90 seconds. In other words it doesn't go into TX at all. I get an elecraft message on the display and my Split operation disappears After I wait for about 15 seconds turn split again , the K2 works fine until the next 90 seconds. Where do I look ? Same thing happens if I run the K2 barefoot, 10 watts without the amp. Thanks for any reply Rich W3ACO S/N 4023. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
