Date: Sun, 04 Feb 2007 14:51:48 -0800 From: Fred Jensen <[EMAIL PROTECTED]>
Takes me about 5 mins ... 3 to find the phillips screwdriver, and 2 to change the tops. Be careful of the two screws in the top middle of the side plates. They screw into the heat sink and it is easily stripped. It's very easy to actually drill and tap the heat sink from the side, then use a 1/2" length 4-40 screw at that location. As shipped, you're using a short #5 screw into the slot in the heatsink, and it strips very easily. 73, doug _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
