Thanks, Larry, those figures are in themselves impressive. Of course, a lot depends on the mesurement equipment and conditions. Worth adding perhaps to the Elecraft resource list.. My L-4's -33db compared to single tone (-39db cf. pep), would in that case be the limiting factor. Maybe a good excuse for a new rig.
73 Wyn, VR2AX ----- Original Message ----- From: "Larry Phipps" <[EMAIL PROTECTED]> To: "Wyn Hughes" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Friday, February 16, 2007 9:48 PM Subject: Re: [Elecraft] KPA100 IMD Distortion Figures > Take a look at the tests run by Jack, K8ZOA, using his Z90 Panadapter > kit at cliftonlaboratories.com Click on the IMD Measurements link. He > shows the test methodology, and results from several rigs, including his > K2/100. > > 73, > Larry N8LP > > > > Wyn Hughes wrote: > > Hello Group, > > > > Has anyone measured, or have any information, regarding the 3rd/5th order IMD performance of the barebones KPA100, based on a two-tone test? > > > > I have some figures for the base K2, courtesy of the ARRL review. I might even have seen figures for the K2/100, but can't seem to locate them at present. If anyone can also supply these figures, I would be grateful. > > > > > > 73 > > Wyn, V2AX > > > > _______________________________________________ > > Elecraft mailing list > > Post to: [email protected] > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > > > > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
