Les, It may or may not be a problem. You should turn to the DC voltage chart and measure the DC voltage on each of diodes D1 thru D8. If all of the voltages are roughly 10% low, it is not a problem, but if you have a bad diode, or one of them oriented the wrong way, the variation will be much more than 10%.
73, Don W3FPR > -----Original Message----- > > I have just got around to building the KPA100 (to Appendix G - > Rev. C-5) for > my K2 (53 * * ), and I have got to the voltage test on R12, on page 47 of > the manual, where it asks to verify that the voltage is within the > 100 -110VDC range. Upon performing this check, mine can only > manage 91V, Is > this OK or do I have a problem?. > > 73, > Les M0BSI > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.446 / Virus Database: 268.18.3/700 - Release Date: 2/24/2007 8:14 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
