Hello,
Use a lighted match stick or cigarette lighter to burn away the
enamel(carefully), then use fine sand paper, and Surgical Spirit on a
cloth to clean away the dirt.
Solder wire should have special flux to capture the rest of the dirt
to make tinning easier.
You will find that the wires will be easier to tin, after this.
Andrew(KI4LTH/5Z4FT)
K1, T1, Hopeful
http://www.qsl.net/5z4ft/index.html
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
