Hello Don and Ron:
I got my new power module in the mail today and it went right in without a hitch. Alignment at that point went very smooth. I used a DL-1 to measure voltage and then chart it out to 20 watts. My LP-100 is waiting to be built. :-) I figured 22 volts was about 20 watts and that worked great. All the other parts of the alignment went fine except: Part IX: Overload Protection test - I couldn't get this to work. Removing the jumper JP8 removes power from the transverter. This can be turned on manually with the power switch, but I left it off as the instructions said nothing about it. Removing the serial control cable, disables the transverter entirely - no power with or without the front switch on. Keying the transmitter resulted in nothing except a higher SWR light on the KAT100. LO Oscillator Frequency Calibration: Using my Mark V on 12M, I find I'm off on 6M by about 700 Hz. But where the heck is Z6 trimmer capacitor. I suspect it should be C64, since I haven't touched that one yet. :-) 73, Jamie WB4YDL _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
