Don, Thanks for the quick response. I hope it is something this simple (stupid)! I will go back and try again. I was reading the power and the SWR, so I thought that should have been transmitting full power.
I did take the KPA100 apart and checked soldering, checked for possible shorts, etc. and found nothing but RFC1 soldering not looking great - will check that connection before I reassemble the unit. 73, Tom KG3V Quoting Don Wilhelm <[EMAIL PROTECTED]>: > Tom, > > How are you initiating transmit? If you are pressing the TUNE button, the > power level will be about 20 watts, you must press TUNE and DISPLAY to > transmit at the full requested output. > > 73, > Don W3FPR > > > -----Original Message----- > > > Just finishing KPA100 assembly. All looks good up to the high > > power transmit > > tests. I am setting the power control to 100 watts. Power indicator when I > > transmit says I only have 21-25 watts out on all bands. > > > > I am looking over the workmanship, guessing that maybe the final > > stage is not > > working at all. Any help greatly appreciated. > > > > 73, > > > > Tom KG3V > > > > > -- > No virus found in this outgoing message. > Checked by AVG Free Edition. > Version: 7.5.446 / Virus Database: 268.18.8/717 - Release Date: 3/10/2007 > 2:25 PM > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
