Hello group,
Its been a Elecraft month, first the KX1 and now I just finished up
the K1.
After three evenings of effort I was able to complete K1 serial
#02341 last night and go through the testing procedure.
All went quite well, but I have a few questions, perhaps some of your
other K1ers can help?
1) The front panel "offset" pot alters the RX frequency even when RIT
is off.
With the RIT off, turning the pot causes the displayed freq. changes,
and does the same thing with the RIT is engaged as well.
Is this normal, or do I have a problem here?
2) What are your thoughts on the battery option offered by Elecraft?
3) Is there a small bail or support that anyone has used to raise the
front of the RX up a bit?
Mine is now sitting on a roll of solder, but some type of flip down
bail would be ideal
4) Noise blanker, how well does it work? I built mine last night and
installed it, not quite as a severe as I expected.
I understand an LED can be used in place of one of the caps, can
someone speak to the difference this makes?
Thanks for your help!
73 Bruce W1UJR
www.w1ujr.net
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
