Hank,
The newest manual calls for greater than 11.2 ohms. You must be using
an older manual. You are just fine with 11.4 ohms.
73,
Don W3FPR
Hank Kryger wrote:
Hi to the group
I completed my K2 and now am building the KPA 100. Manual Rev C, Feb
2004.
On page 41, "Alignment and Installation" Resistance measurements are
made between ground and test point. J3, Q1 Collector, Q2 collector, and
Q9 tab are all within the the spec,s as listed in the table. Q1 base
and Q2 base to ground I get lower then expected resistance values. 11.4
Ohms.
Should I be concerned about this reading since the manual calls for 12 -
16 ohms?
I also had some problems getting a reading at D13 cathode end. After
several tries I did get a reading according to spec,s.
thanks for any assistance, 73's Hank WA9QJH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
