Rafal,
Those are just jumper wires in the audio path (see the schematic), so
there is nothing special about them other than that they need to exist.
If you plan to install either the KAF2 or the KDSP2, intall the jumpers
so that you can easily remove them. In fact, if you have the KAF2 or
KDSP2 kit in hand, you may want to consider installing the headers and
then put in temporary jumpers.
73,
Don W3FPR
[EMAIL PROTECTED] wrote:
Hello,
I have a question regarding wire jumpers replacing resistors R18
and R19 on the control board.
Should these jumpers be installed on the bottom of the control
board and soldered on the top or installed on the top of the board
and then soldered on the bottom of the control board ?
Does it have any special meaning ?
73 de Rafal SP9IVD
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
