Any 'pushing' on the components risks damage to the board. I'd
consider it the same as rework.You either need a good desoldering
system and some skill to clear the hole, or you destroy the component
and replace it.
A practical solution is to simply live with elevated component.
Mark AD5SSS
On 4/3/07, Rodney Macpherson <[EMAIL PROTECTED]> wrote:
I have tried the following:-
1. push with finger [too painful]
2. Use a glove [too bulky]
3. Use pliers [risk of damaging component]
Possible solutions
Push with Cork, with groove cut in end to reposition component
Push with small Alligator clip.
Praticasl solutions would be welcomed,
Rod
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
