Ron Polityka wrote:
Hello,
I finally found my RIGblaster plus unit but I can't find my book.
Just playing around with the RIGblaster I can receive via the sound card
with out any problems. I placed the K2 into VOX and I go to transmit and
all
seems fine but it does not send anything. Then I tell the unit to receive
but it will not receive unit I take the Mic jack out of the front of the
K2.
Anyone else using the K2 and RIGblaster plus for PSK31?
Onto looking for the manual.
72 and Thanks,
Ron Polityka
WB3AAL
www.wb3aal.com
www.n3epa.org/
K1 - SN 01011
K2 - SN 01392
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
Hi Ron.
I've got that same setup and it works great.
Get to the West Mountain website and download a Rigblaster plus manual.
You need that to double check the jumper settings inside the rigblaster
and the cabling.
If setup properly you don't need to use VOX to transmit as the
rigblaster will kick over the PTT through the mic cable.
Looking at the online Rigblaster plus manual and check page 8 for the
Alinco, Kenwood, SGC, Elecraft jumper setup.
Good luck.
--
R. Kevin Stover ACØH
K2/100 #4684
Reclaim Your Inbox!
http://www.mozilla.org/products/thunderbird
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
