Ken,
I agree, The holes in the assemblies are not "sloppy". They are
however a small bit larger than the minimum required clearance size for
4-40 screws.
That slightly larger hole size allows tolerance for any paint buildup
inside the holes, ease of screw insertion and does allow a tiny bit of
adjustment for the assembled enclosure as well as a bit of adjustment
for the placement of the 2-D connectors.
Anyone with a case that is a bit 'wobbly' can usually cure it by putting
the tilt bail in the down position and placing the enclosure on a flat
surface - then loosen side panel, rear panel and top panel screws a
little bit and apply a slight downward pressure to the enclosure while
tightening the screws. After that, any "wobbliness" that occurs when
the tilt bail is upright can be taken care of by adjusting the tilt bail
attachment feet a bit in a front-to-back direction.
73,
Don W3FPR
Ken Kopp wrote:
I don't agree with the concept of "sloppy holes" being
needed or having been designed into the K2 case.
On the contrarty, the mechanical "fit" of the cabinet
parts/panels is IMPRESSIVE!
Having a background that gives me some insight into
what's going on behind the scenes, this simply jumped
out at me when I started the assembly of the kit.
It takes a good bit of effort and attention to detail to
produce a product of this caliber. Said another way,
it's all in the details.
Elecraft is a study in contrast when compared to MFJ,
and Ten-Tec. (:-))
73! Ken Kopp - K0PP
[EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
